Nissan D22 Navara 2.5L Exhaust 3" Turbo Back No Cat With Muffler Black Aluminised Steel
2007 - 2015
Share this product:
PRODUCT DETAILS:
Playtime Ignite 3" (76mm) Turbo Back Sports Exhaust System - Black Coated
Fits:
NISSAN NAVARA D22 2.5L YD25DDTi TURBO
SINGLE / DUAL CAB UTE
2007 - 2015
FITS: SPANISH AND THAI BUILT
Features:
CNC 3" Mandrel Bent
Durable 3” Aluminised Steel Tube
10mm Thick Laser Cut Flange Plates.
Exhaust Temp Provision (EGT)
Cat Eliminator Pipe
High Flow Sports Muffler
Fitting Kit included
2 Year Manufacturer Warranty
MADE IN AUSTRALIA
Benefits:
Increased Performance and Fuel Economy
Extreme durability
Will not require ECU remapping or dyno tune
Optional Direct Fit Muffler, Resonator, or Pipe
Available for over 50 makes and models
Ultimate towing advantage
Quick and easy install
Australian Made
2 year warranty
*** Performance and Economy gains can vary for each vehicle***
***Disclaimer: Check over exhaust making sure everything is aligned and then tighten all bolts and nuts from the front to back of the vehicle. If you have any fitting/alignment issues, please call us as soon as possible to avoid damaging the exhaust system.***
SKU | ND2225BPDCDM |
Brand | Ignite |
Shipping Weight | 24.0000kg |
Shipping Width | 0.390m |
Shipping Height | 0.250m |
Shipping Length | 1.300m |
Shipping Cubic | 0.126750000m3 |
Unit Of Measure | ea |
- Remove rear tail pipe and muffler assembly from the vehicle.
- Remove centre connecting pipe and flex join pipe from the vehicle.
- Remove gear box bracket.
- Unbolt the four tail shaft bolts and move tail shaft to the side.
- Remove turbo dump pipe heat shield.
- Remove turbo dump pipe. We advise to spray the 2 nuts and 2 bolts with WD40 before removing. Hint: It is sometimes easier to remove the bottom RHS turbo bolt from underneath the car using an extension bar.
- Insert the supplied EGT plug into the turbo dump pipe.
- Fit the turbo dump pipe section to the turbo outlet flange using the two supplied M10x1.25 nuts, two M10x1.5 studs and two M10x1.5 nuts. Tighten all 4 nuts.
- Fit the front pipe section to the turbo dump pipe and tighten finger tight with the supplied 3/8 UNC nuts.
- Re fit the tail shaft back into place using the four factory nuts and bolts.
- Fit the cat/cat delete flex section to the front pipe and tighten finger tight with the supplied 3/8 UNC nuts.
- Re fit the gear box bracket as per image 1 using the four supplied nyloc nuts, washers, and bolts and two of the factory gear box bolts.
- Fit the pipe only/resonator or muffler section to the connecting pipe and tighten finger tight with the supplied 3/8 UNC nuts.
- Fit the tailpipe to the pipe only/resonator or muffler section and tighten finger tight with the supplied 3/8 UNC nuts.
- Check over exhaust making sure everything is aligned and then tighten all bolts and nuts from the front to back of the vehicle.
- Enjoy your IGNITE exhaust!