Ford PX Ranger Exhaust 3.2L 3" Turbo Back No Cat With Pipe Black Aluminised Steel
2011 - 2016
Make 4 payments of $125.00 over 8 weeks and get it now!
Share this product:
PRODUCT DETAILS:
Playtime Ignite 3" (76mm) Turbo Back Sports Exhaust System - Black Painted
Fits:
FORD RANGER PX / PX2 3.2L ZSD-532 TURBO
SINGLE / DUAL CAB UTE / EXTRA CAB
2011 TILL 09/2016
NON DPF MODEL ONLY
Features:
CNC 3" Mandrel Bent
Durable 3” Aluminised Steel Tube
10mm Thick Laser Cut Flange Plates.
Exhaust Temp Provision (EGT)
Cat Eliminator Pipe
Sports Muffler Delete Pipe
Fitting Kit included
2 Year Manufacturer Warranty
MADE IN AUSTRALIA
Benefits:
Increased Performance and Fuel Economy
Extreme durability
Will not require ECU remapping or dyno tune
Optional Direct Fit Muffler, Resonator, or Pipe
Available for over 50 makes and models
Ultimate towing advantage
Quick and easy install
***Disclaimer: Check over exhaust making sure everything is aligned and then tighten all bolts and nuts from the front to back of the vehicle. If you have any fitting/alignment issues, please call us as soon as possible to avoid damaging the exhaust system.***
SKU | FPX32BCDP |
Brand | Ignite |
Shipping Weight | 20.0000kg |
Shipping Width | 0.390m |
Shipping Height | 0.250m |
Shipping Length | 1.130m |
Shipping Cubic | 0.110175000m3 |
Unit Of Measure | ea |
- Remove rear tail pipe and muffler assembly from the vehicle.
- Remove centre connecting pipe from the vehicle.
- Remove turbo dump pipe heat shield.
- Remove catalytic converter from vehicle. Hint: Access lower turbo nut through
- the RHS wheel arch.
- Remove turbo nuts/bolts and replace with providing studs M10x1.5, nuts M10x1.5. Some will need two replaced as some may only need one replaced.
- Insert the supplied EGT plug into the turbo dump pipe.
- Fit the turbo dump pipe to the turbo outlet flange using the three supplied M10x1.5 nuts. Tighten all 3 nuts.
- Fit the connecting pipe to the to the turbo dump pipe and tighten finger tight with the supplied 3/8 UNC nuts.
- Fit the second connecting pipe to first connecting pipe with the integrated hanger mount aligning with the rubber hanger located on the side of the chassis, tighten finger tight with the supplied 3/8 UNC nuts.
- Fit the pipe only/resonator or muffler section to the connecting pipe and tighten finger tight with the supplied 3/8 UNC nuts. (Fit diff pipe section in the same format if that’s what you purchased and then continue with step 12)
- Fit the tailpipe to the pipe only/resonator or muffler section and tighten finger tight with the supplied 3/8 UNC nuts.
- Check over exhaust making sure everything is aligned and then tighten all bolts and nuts from the front to back of the vehicle.
- Enjoy your IGNITE exhaust!