PRODUCT DETAILS: 

Playtime Ignite 3" (76mm) Turbo Back Sports Exhaust System - Black Coated

 

Fits:

NISSAN NAVARA D22 2.5L YD25DDTi TURBO

SINGLE / DUAL CAB UTE

2007 - 2015

FITS: SPANISH AND THAI BUILT

 

Features:

CNC 3" Mandrel Bent

Durable 3” Aluminised Steel Tube

10mm Thick Laser Cut Flange Plates.

Exhaust Temp Provision (EGT)

Cat Eliminator Pipe

Sports Muffler Delete Pipe

Fitting Kit included

2 Year Manufacturer Warranty

MADE IN AUSTRALIA

 

Benefits:

Increased Performance and Fuel Economy 

Extreme durability

Will not require ECU remapping or dyno tune

Optional Direct Fit Muffler, Resonator, or Pipe

Available for over 50 makes and models

Ultimate towing advantage

Quick and easy install

Australian Made

2 year warranty

*** Performance and Economy gains can vary for each vehicle***

 

***Disclaimer: Check over exhaust making sure everything is aligned and then tighten all bolts and nuts from the front to back of the vehicle. If you have any fitting/alignment issues, please call us as soon as possible to avoid damaging the exhaust system.***

SKU ND2225BPDCDP
Brand Ignite
Shipping Weight 24.0000kg
Shipping Width 0.390m
Shipping Height 0.250m
Shipping Length 1.300m
Shipping Cubic 0.126750000m3
Unit Of Measure ea
  1. Remove rear tail pipe and muffler assembly from the vehicle.   
  2. Remove centre connecting pipe and flex join pipe from the vehicle.  
  3. Remove gear box bracket.
  4. Unbolt the four tail shaft bolts and move tail shaft to the side.
  5. Remove turbo dump pipe heat shield.
  6. Remove turbo dump pipe. We advise to spray the 2 nuts and 2 bolts with WD40 before removing. Hint: It is sometimes easier to remove the bottom RHS turbo bolt from underneath the car using an extension bar.
  7. Insert the supplied EGT plug into the turbo dump pipe.
  8. Fit the turbo dump pipe section to the turbo outlet flange using the two supplied M10x1.25 nuts, two M10x1.5 studs and two M10x1.5 nuts. Tighten all 4 nuts.
  9. Fit the front pipe section to the turbo dump pipe and tighten finger tight with the supplied 3/8 UNC nuts.
  10. Re fit the tail shaft back into place using the four factory nuts and bolts.
  11. Fit the cat/cat delete flex section to the front pipe and tighten finger tight with the supplied 3/8 UNC nuts.
  12. Re fit the gear box bracket as per image 1 using the four supplied nyloc nuts, washers, and bolts and two of the factory gear box bolts.
  13. Fit the pipe only/resonator or muffler section to the connecting pipe and tighten finger tight with the supplied 3/8 UNC nuts.
  14. Fit the tailpipe to the pipe only/resonator or muffler section and tighten finger tight with the supplied 3/8 UNC nuts.
  15. Check over exhaust making sure everything is aligned and then tighten all bolts and nuts from the front to back of the vehicle.
  16. Enjoy your IGNITE exhaust!